Achsa Home Improvement

Talks about Home Improvement and Decorating

Some Of The Cleaning Instructions For Kitchen Drain

The instructions to be observed minutely

Firstly, the food and the debris that is clogging the drain should be removed and then the kitchen drain should be cleaned and deodorized. The food blocking the pipe should be removed with the hand and some of the instructions how to deodorize the drain are as follows:

The drain should be run with hot water such that any formation of bacteria in the drains can be removed. The hot water should be let down the pipe for about 15 seconds, otherwise there is every possibility of burning the hand. But as in most of the cases the pipes are made of plastic so too hot water can damage the pipe so extreme care should be taken.

A teaspoon baking soda should be used after the use of the hot water. Most people use the baking soda to reduce any kind of odor caused by the drain. This is one of the most common steps which should be used by the people.

Several additional cleaning solutions can be applied if the smell is too much. A cup of cleaning solutions should be applied and suggestions are there that at least half an hour should be waited and then the drain should be rinsed with hot water. Bleaching powder can also be applied in the kitchen sink to reduce odor, but it should be applied in a well-ventilated area.

If the above instructions do not work in the Kitchen sink drain cleaning procedure than a strong solution should be used. Most of these strong solutions are available at some of the local grocery shops.

The customers can also use the following steps for the grease trap cleaning and when a grease trap is cleaned properly ample amount of money can be saved by the customers. Some of the steps for the cleaning of the grease trap are as follows:

The lid of the grease trap should be detached gently with a pry bar. But this process should be done very slowly otherwise serious damage may occur.
Secondly, the grease parts should be inspected properly where re-installation of the process is done.

A measuring stick or a wooden dowel should be inserted into the grease trap so that the grease and oils marks the dowel. Thus, any kinds of debris can be removed from the trap.

With a small bucket the debris should be removed from the grease trap and the solidified waste should be separated. Hence, with these easy steps the grease trap can be cleaned by any individual and with some suggestions from the experts.